Spangle and fuzzy patches are decorative heat-applied patches
• These patches require backing removal before application
🔥 IMPORTANT: Remove Backing First
Before applying, carefully remove the clear or white backing layer from the patch.
⚠️ Do NOT apply with the backing still attached, as the adhesive will not activate correctly.
Heat Press
A heat press provides the best and most durable results.
You’ll need:
• Heat press
• Teflon sheet or parchment paper
Steps:
Remove backing from the patch completely.
Preheat heat press to 300–315°F.
Pre-press garment for 5 seconds to remove moisture.
Place patch adhesive side down on garment.
Cover with Teflon or parchment paper.
Press with firm pressure for 12–15 seconds.
Allow garment to cool completely.
Check edges and re-press for 5–8 seconds if needed.
⚠️ Alternate Method: Household Iron (Use with Caution)
Iron application is possible but less reliable for spangle and fuzzy patches.
Steps:
Remove backing first.
Set iron to High / Cotton (no steam).
Place garment on a firm, heat-safe surface.
Cover patch with parchment paper or thin cloth.
Press firmly for 20–30 seconds (do not slide iron).
Repeat as needed until fully adhered.
Allow to cool completely and check edges.
🧼 Care Instructions
• Wait 24 hours before washing
• Wash inside out on cold, gentle cycle
• Do not bleach
• Tumble dry low or air dry
• Do not iron directly on the patch
⚠️ Important Notes
• Backing must be removed prior to application
• Not recommended for heat-sensitive fabrics
• Professional heat application is strongly recommended
• Improper application may cause lifting or damage
Questions about compatibility or application? Contact us before ordering.
📧 Contact: info@tlckraftydesigns.com